Aim: To enhance appropriate
engineering skills, technique and procedures of Basic PC operation.
Objective: On
completion of this training module, the trainee will be able to know :
Computer definition, Information Processing System, Units of measurement, Hardware of PC system & Software of PC System etc
TEACHER:-
ANUP KUMAR
WORKSHOP(HRD)
Aim: To create safe working environment by enhancing appropriate
engineering skills, technique and procedures related to Electrical Safety in the Workplace.
Objective: On
completion of this training module, the trainee will be able to learn:-
बिजली के
नियम,कर्मचारियों के लिए व्यक्तिगत
सुरक्षा उपकरण,औजार एवं
उनका उपयोग,विद्युतीय खतरा,विद्युत झटका लगने पर प्राथमिक उपचार विद्युत से
सम्बंधित गलत अवधारणायें & CASE
STUDIES etc.
Aim: To create safe working environment by enhancing appropriate
engineering skills, technique and procedures related to reduction in re-annealing coils to less than 1
% of annealed coils.
Objective: On
completion of this training module, the trainee will be able to learn : Material flow in CRM 1&2, zones of cold rolling
mill 1&2, introduction to cold rolling, about annealing process, purpose of
bell annealing process, plc annealing
cycle in annealing ii , reasons of coil
oxidizing ,reasons for
generation of oxidized coils in annealing & rectification of
defects etc.
- Aim:- The aim of the e-module is to enable the learner to understand the Basic of S7-400H Redundancy Siemens PLC.
- Objectives: At the end of the course, the participants will be able to demonstrate the understanding.
- Functions and technical specifications of the central processing units, power supply modules and interface modules of the S7-400H Redundancy PLC.
- How to configure, assemble and wire these modules (and other) in an S7-400H system is described in the installation manuals for each system.
Aim: To create safe working environment by
enhancing appropriate engineering skills, technique and procedures related to dissolution
of lime in converter Steelmaking.
Objective: On completion of
this training module, the trainee will be able to learn: Principle of blowing in LD converter ,operations in SMS II converter at BSL ,lime as flux in converter
,slag path ,dissolution of lime , lime analysis of SMS II BSL & solutions
for better utilization etc .